Frequently Asked Questions (FAQ)
As BARGEM, we have compiled the questions we are asked most often on this page.
If you cannot find the answer to a question, you can always reach us by filling in the form below.
Technical requirement analysis, cell and BMS selection, electrical/mechanical design, prototyping, testing and validation are the common stages. Design steps may vary according to the safety, size and performance requirements of the application. For more information, please see our battery engineering processes page.
A BMS monitors data such as cell voltages, current and temperature, and performs protection and control functions depending on its design. It can help protect the system in situations such as overcharge, over-discharge and overcurrent. For more information, please see the BARGEM R&D Centre page.
Differences in charge level or voltage between series-connected cells can limit the usable capacity of the battery pack. Where supported, cell balancing manages these differences and helps the battery operate consistently. For more information, please see our BMS laboratories.
BARGEM carries out R&D activities in battery packs, management and protection systems, thermal management, charging technologies, and testing/analysis. Its work aims to develop new products and engineering solutions for different sectors. For more information, please see the catalogues page.
Capacity testing measures the charge/energy that can be drawn from a battery under defined conditions. Safety and durability tests aim to verify performance under certain demanding conditions. The methods used are determined by the product chemistry and the target standard. For more information, please see our cell and battery testing services page.
Through the BARGEM infrastructure and, where necessary, expert partners, we offer electrical performance, environmental conditions, mechanical durability and safety assessments for cells, battery packs, BMS and charging systems. The scope of testing is determined according to project requirements. For more information, please see the scope of our testing services page.
In the after-sales process, technical inspection, fault diagnosis and performance evaluation of cells and batteries are carried out. The condition of products is analysed through capacity, charge-discharge and internal resistance tests; capacity loss, cell imbalance, connection problems and BMS-related faults are investigated at cell and battery pack level. After the probable root cause of a fault is identified, cell balancing, recharging, maintenance and repair are applied to suitable products. In line with the test results, customers are given technical information and solution recommendations, and improvement work is carried out in coordination with production units to prevent recurring faults and increase product reliability.